C51 Clock Kit
I bought one of these Chinese kits recently from ebay (£1.62) - you can′t grumble
about the cost. I get the feeling though that the kit was made
down to a price instead of up to a quality. The pcb is single
sided and measures 42mm x 52mm (1.65" x 2.04") with silk screening on the component side. The clock is based on a pre-coded
micro controller chip (AT89C2051). Assembly is straight forward
enough - there are tutorial videos on Youtube (here and here - there are probably a few more if you search). What is missing
however is some instruction on how you actually set and use
it.
The clock runs from 5 volts DC. Mine consumes 35mA with all the digits on. I
purchased a 5 volt power supply on a 13A plug to power the
clock up.

I also got a female adaptor to convert the 2.1 mm plug to ordinary wires as the cable on the 5V power supply was a little short.
Firstly applying power the display shows 12:59 and the semicolon flashes. The two buttons can now be used to set the clock functions. In "Set" mode, the display will go from "A" to "I" to enable various parameters to be set by the "Adjustments" button.
Setting the clock:
SW1 (left button) = Setting mode
SW2 (right button) = Adjustments
A Set Hour
B Set Min
C Set Chime on / off (no idea what this is)
D Set Alarm 1 on / off
E Set Alarm 1 Hour
F Set Alarm 1 Min
G Set Alarm 2 on / off
H Set Alarm 2 Hour
I Set Alarm 2 Min
I include a zip here with some other stuff. I would be interested to hear how other folks mounted the pcb - it′s very densely populated and doesn′t have a fixing hole in each corner (only one near the left hand side).
